![]() Do not cover the back or the bottom of the probe, if you have problems triggering the probe, try removing bits of the tape as it may be interfering with probe sensing. We recommend covering the front and sides of the probe with at least 2 layers of this tape. This tape is used to help insulate the Z probe from radiative heat from the the hotend. ![]() Our kit comes with a small strip of fiber glass tape. We recommend connecting the end with the label to the controller and the end without the label to the XY endstop PCB. The XY endstop cable has the same 4pin JST-XH connector on both ends but only one end has a label. The mounting of the PCB uses the M2 self-tapping screws using the screw hole on the microswitch rather than 4 screws of the bottom in the assembly manual. The Z-endstop mounts to the extrusion using M3x25 SHCS rather than the M3x20 SHCS in the assembly manual. Our Z-endstop is slightly different from the official endstop, use our printed part. Note: The probe 24v pin is not configurable using jumpers on the MCU. For the Klicky probe the 24v probe pin will not be used. The LDO toolhead PCB is for Clockwork 1 extruder with either the Afterburner or Stealthburner toolheads. Refer to the photos in the later chapters to check the final orientation. The motor should be installed in a way so that the connector faces outwards towards the skirts.This will free up a small amount of space and prevent any interference with the other components in the electronic compartment. In our guide, the orientation of the Z stepper motors are slightly different from the official manual. ¶ Above Deck Wiring ¶ Z Stepper Orientation You may choose to cut them or leave them as is during wiring. Toolhead PCB cable ( Remove the zipties before installation into the cable chain, you will want to add back zipties at the cable chain ends where there is no movement.)Ĭertain stepper motor cables are purposely left longer than needed for people with different setups.Heatpad, joined with thermal fuse and installed on bed. ![]() The following items should have pre-cut lengths, labels, and crimped connectors: Multimeter (not included in kit), Used to check connectivity. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |